WEEK 11 (chapter 3)
Thursday, May 11, 2017Flow Chart
The flow charts refer to the
process of the project which is starting from the camera. After all the power
on, the PIR sensor starts to detect periodically the movement of object in or
out of the sensors range. If there is no motion in the detecting area, the
system will go into power saving mode. In contrast, LED positioned inside the
base that will light up anytime when the PIR sensors detect any motion according
to the code that uploaded in Arduino. Then, servo motor that is attached to the
stand where the camera sits, will rotates the camera to wherever the motion was
detected. The process will repeat when another motion was detected in the same
time and it will stop when the PIR sensor not detects any motion in its range.
Therefore, it is well suited to be apply in daily life and it is suitable to
use for everyone.
0 comments